The OMS 420 Ex is an in-situ oxygen and COe monitor designed for continuous combustion optimisation in hazardous area zones.. It is ideal for various industrial furnaces, ovens, and boilers with hazards of explosive atmospheres. Petruoleum refinery plants, petrochemical plants, gas separation, blast furnace, coke oven and other syngas plants are all excellent candidates for the OMS 420 Ex.
-Hazardous
area designation of use: Zone 2 or Class 1, Div 2, Gr A/B/C/D
-Special IP 65 pressurized
cabinet and z-purge controller, complying to II 3G Ex pz II T3 Gc
-On site replaceable detector
head with sensors (O2 & COe)
-Integrated control unit with
backlit display, operating key pad, dual galvanic isolated 4 … 20 mA output and
digital output RS 485 (Modbus RTU)
-Stainless steel SS316Ti flange
4″ ANSI-150Ibs with flow guidance probe tubes, from 11.81“ up to 78.81“ length
-Unique hot solid electrolyte sensor for
combustible COe-measurement without need for sample dilution with air as
required for catalytic bead sensors (Pellistors) (Option)
-Unique blow-back system for dusty flue gases
(Option)
-Integrated auto-calibration for accurate
measurements (Option)
-Dust tight and water proof enclosure, with optional ATEX heater for very low ambient air temperatures or optional ATEX Vortec cooler for high ambient temperatures
The SWG 100 CEM is a stationary analyzer meant for continuous emission monitoring. It works best for industrial applications using..
The SWG 300-1 is a multi-component extractive cold-dry gas analyzer. The NDIR modules measure continuously, selectively and highly..
OMS 420 Datasheet